RCF ES3160 - Page 10

33
ENGLISH
1.
MIX – MUSIC OFF
MIX: the music source (internal or
external) is always present in the (mixed)
signal sent to the amplifier, even during a
priority command.
MUSIC OFF: the music source (internal or
external) is not sent to the amplifier during
a priority command.
2.
PRIO INPUT 1
PRIO INPUT 2
PRIO INPUT 1: the channel 1 has the
highest priority level with override (but
the CHIME SEQUENTIAL COMMAND)
through the relevant command (or VOX),
if the dip-switch no.3 has been set to
‘graduated priority’.
PRIO INPUT 2: the channel 2 has the
highest priority level with override (but the
CHIME SEQUENTIAL COMMAND) through
the relevant command, if the
dip-switch no.3 has been set to
‘graduated priority’.
3.
INTERLOCKED
GRADUATED PRIOR.
INTERLOCKED: interlocked priority mode
(read the ‘Operation’ section).
GRADUATED PRIOR.: graduated priority
mode (read the ‘Operation’ section).
4.
OFF
VOX ON INPUT 1
OFF: the channel 1 VOX function is off.
VOX ON INPUT 1: the channel 1 VOX
function is on (automatic priority when a
signal is detected on the audio INPUT 1).
5.
OFF
SMART INPUT 2
OFF: the channel 2 priority is kept only
if the relevant command is still present
(‘push’ mode).
SMART INPUT 2: the channel 2 priority is
switched on / off by every impulse of the
relevant command (‘toggle’ mode).
6.
OFF
SMART INPUT 3
OFF: the channel 3 priority is kept only
if the relevant command is still present
(‘push’ mode).
SMART INPUT 3: the channel 3 priority is
switched on / off by every impulse of the
relevant command (‘toggle’ mode).
7.
SHORT
CHIME LONG
SHORT: short chime. CHIME LONG: long chime.
8.
CHIME
SIREN ON SEQ. CMD
CHIME: the chime (selected by the dip-
switch no.7) is continuously played when
the ‘CHIME SEQUENTIAL COMMAND’ is
activated.
SIREN ON SEQ.CMD: an alarm tone is
sent when the ‘CHIME SEQUENTIAL
COMMAND’ is activated.
o 8 dip-switches PRESET to set the priority options: