RCF QPS 9600 - Operation Modes; Four Independent Channels

11
ENGLISH
OPERATION MODES
As alternative wiring, it is possible to use just a pair of SPEAKON connectors
(by using all the four pins): one for the channels A and B, one for the channels C and D.
FOUR INDIPENDENT CHANNELS
Make sure the amplier is switched off before setting:
- the BRIDGE A+B switch
10
to OFF
- the BRIDGE C+D switch
11
to OFF
- the switch
15
to FOUR INDEPENDENT CHANNELS.
All the four channels are completely independent and each front panel level control
affects its respective speaker output.
Minimum load impedance is 2 Ω per speaker output.
1+
2+
1–
2–
1+ 1– 1+ 1– 1+ 1– 1+ 1–
AAC
BRIDGE C+D BRIDGE A+B
FOUR INDIPENDENT
CHANNEL
BCD
D BC A
SPEAKER OUTPUTS
C(+D) A(+B)D B
+ 1+
– 2–
BRIDGE
+ 1+
– 2–
BRIDGE
1+ CH D+
1– CH D–
1+ CH B+
1– CH B–
PUSH PUSHPUSH PUSH
1+ CH A+ 2+ CH B+
1– CH A– 2– CH B–
1+ CH C+ 2+ CH D+
1– CH C– 2– CH D–
1+
2+
1–
2–
1+ 1–2+ 2– 1+ 1–2+ 2–
ABCDAC
BRIDGE C+D BRIDGE A+B
FOUR INDIPENDENT
CHANNEL
C AD B
SPEAKER OUTPUTS
C(+D) A(+B)D B
+ 1+
– 2–
BRIDGE
+ 1+
– 2–
BRIDGE
1+ CH D+
1– CH D–
1+ CH B+
1– CH B–
PUSH PUSHPUSH PUSH
1+ CH A+ 2+ CH B+
1– CH A– 2– CH B–
1+ CH C+ 2+ CH D+
1– CH C– 2– CH D–