RD RDC6445G - Description of Interface Signal for Mainboard; Interface of Main Power Source Cn0; Panel Signal-Cable Interface HMI; Udisk Interface

Shenzhen Reader Technology Co., Ltd
10
4 Description of Interface Signal for MainBoard
4.1 Interface of Main Power Source CN0
This control system employs single 24 power supply. For a certain
margin, it is suggested to select 24V/2A power. Besides, this system is
compatible with 36V power, that is to say, the 36V power of Motion
driver can directly be connected to this main power port of this system,
but generally it is not suggested to do so.
4.2 Panel Signal-Cable Interface HMI
The panel signal-cable is a pin-to-pin cable, which is included in the factory shipper
bill.
4.3 Udisk Interface
Udisk is a USB-AM interface. The controller may visit the u-disk by this interface.
4.4 PC-USB Interface
PC-USB is a USB-BM interface. The controller may communicate with PC by this port.
4.5 Ethernet Interface
Using this interface, the mainboard can communicate with PC by 10/100MHZ
Ethernet.
Pin
Symbols
Definitions
1
GND
24V power ground (input)
2
+24V
24V power positive (input)
Caution