©2019, REC TEC Industries, LLC
Questions? CLICK for support!
Back to Table of Contents
Issue Potential Cause Solution(s)
Power
Fuse
Ignitor
Auger motor
Control board
Replace fuse manually and try
again. Call Customer Service or
visit RECTECGRILLS.com if problem
persists.
Remove cooking grates, ame
deector, and drip pans; visually
inspect re pot and if after 10
minutes:
•Your pellets are feeding
•Your blower fan is running and
your grill is still not lighting;
then your ignitor rod may need
to be replaced.
Call Customer Service.
Remove cooking grates, ame
deector, and drip pans; visually
inspect auger turning in the re pot.
(Note: the auger turns very slowly).
If auger is not turning, you may
have an obstruction in your hopper.
Clean out pellets and try again. If
problem persists, your auger motor
may need to be replaced.
Call Customer Service.
Unplug grill. Check to make sure
the fuse is intact and has not blown.
Check for any loose wire
connections. If any wires have
become detached, refer to:
Grill will not
light / turn on
30
We pride ourselves on our grills, grilling accessories, and on
our commitment to serve you. Please consult the chart below
to help resolve issues you may encounter.
Also, please don’t hesitate to contact us with any issues.
Controller Schematic
Controller Schematic
Make sure power is plugged into
working GFCI outlet, and outlet is
not tripped. Unplug grill and check
for blown fuse; refer to:
To Next Page
Loading...