Beijing Reci Laser Technology Co., Ltd
User Guide for Single Module Fiber Laser
(2)Please take good care of the black protective cap of QBH
from being polluted; otherwise, it will cause indirect pollution to
QBH output head when the protective cap is put on.
(7) After the installation or connection of the cooling system, optical system,
electrical wires, remember to do a recheck: make sure the connection of the
electrical system is correct (see section 4.3-4.5 for details), the capacity of the
electrical supply power is the one (AC220V or AC380V, 50Hz/60Hz), and
the ground connection is available.
CAUTION:
Never do the recheck with any electrical switch on, especially the
air switch for the AC 220V or AC 380V on the wall.
(8) Handle gently with the QBH while installing or removing it.
(9) Keep the deliver cable a minimum bending diameter of 400mm for storage,
or 600mm for laser on.
CAUTION:
(1)please make sure the laser optical output and the processing
head cable should be kept as natural as possible and not be
distorted
(2) Too small bending diameter for the deliver cable will damage
the device.
To Next Page
Loading...
Need help?
General
