reci FC3000 - Chapter 5 Use of Monitoring Software; Connect

Beijing Reci Laser Technology Co., Ltd
User Guide for Single Module Fiber Laser
31
indicator automatically turns off when laser is emitted, and turns on when
laser is off.)
Chapter 5 Use of monitoring software
The Monitor software for the single module series Fiber Laser, even the
followed products of the same series is the same, take monitor for FC3000 as an
example.
5.1 Connect
Connect 485 connecting wire to the 1st & the 2nd pin of Rear panel's
CTRL_INTERFACE (which has 16 pins). The 1st pin connects to the T/R+ port of
the wire, the 2nd pin connects to the T/R- port of the wire.
Figure 5.1 the connection of 485 interfaces
Then connect the other side of 485 wire to a computer which is installed the
software.
Open the software. Click to Setting page
（
as the figure 5.2
） ，
Select the
corresponding serial Num
，
Click “open port” button. After choosing the right one
，