EasyManuals Logo

red lion P16 User Manual

red lion P16
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
<.86
:(,&
ANALOG OUTPUT RANGE (OPTIONAL)
6.06 V 6.86 mA
<.86 mA
Select the type of output and range. The Analog output
jumpers are factory set to current. They must be changed if
voltage output is desired. The Analog output can be calibrated to
provide up to approximately 5% over range operation (0 mA
current can only go slightly negative).
6
:(%,
ANALOG UPDATE TIME (OPTIONAL)
6 to 8=6 seconds
6 = update rate of 0.1 second
The update time of the Analog Output can be used to reduce
excess valve actuator or pen recorder activity.
6
4;-'
ACCESS CODE
.08= to 08=
-1)&
)&
-1)&
"&
*1-'
&1-
*1-'
:#
The following parameters can be configured for
#"4, *1-', and -1)&.
#"4
)&)#
*1-'
)&+&
#"4
,+2/
*1-'
,%('
#"4
:#+)
The following parameters can be configured
for
#"4 or *1-' only.
"&
:(:)
ANALOG OUTPUT ASSIGNMENT (OPTIONAL)
This setting selects the parameter that the Analog Output will
retransmit or track.
ANALOG LOW SCALING (OPTIONAL)
.555 to 5555
The Analog Output assignment value that corresponds to 0 V,
0 mA or 4 mA output as selected.
ANALOG HIGH SCALING (OPTIONAL)
.555 to 5555
The Analog Output assignment value that corresponds to 10
V or 20 mA output as selected. An inverse acting output can be
achieved by reversing the low and high scaling points.
STEP 7.3 MODULE 3 - Lockout Parameters (3.#4)
PARAMETER MENU
SELECTION DESCRIPTION
dISP
HIdE
Hide: accessible in Hidden Loop.
LOC
Locked: not accessible in either loop.
dSPr (SP only)
Display/read: read only in Display Loop,
but read/write in Hidden Loop.
Display: accessible in Display Loop.
676
:(#"
06676
:(*1
"&
Main Control % Output Power
12&
SP
Active Setpoint
Input Signal Retransmission
SETPOINT
ACCESS
OUTPUT
POWER
ACCESS
PID VALUES
ACCESS
ALARM
VALUES
ACCESS
SETPOINT
SELECT
ACCESS
AUTO-TUNE
START
ACCESS
SETPOINT
RAMP
ACCESS
CONTROL
TRANSFER
ACCESS
RESET
ALARMS
ACCESS
0
Full access to Display, Hidden,
and Configuration Loops
-1 to -125
Code necessary to access
Configuration Loop only.
1 to 125
Code necessary to access
Hidden and Configuration Loops.

Other manuals for red lion P16

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the red lion P16 and is the answer not in the manual?

red lion P16 Specifications

General IconGeneral
Brandred lion
ModelP16
CategoryController
LanguageEnglish

Related product manuals