Redback SI5000 - Bluetooth

Operation
14 Owner’s Guide – Redback Smart Inverter – v1.4
Bluetooth
BLE onboarding is required if ethernet is not available–a Bluetooth connection is established between the inverter and the
MyRedback app, and the app will guide you through the process of connecting the inverter to your Wi-Fi network.
To onboard using Bluetooth:
1. Go to your inverter. Ensure your home network signal is Good or better at this location.
2. Shutdown and restart your system, as described in sections 9.1 and 9.2.
3. Wait for the status LED to begin flashing continuously, indicating Bluetooth is advertising.
4. On your device, open MyRedback and login. Touch the Hamburger to display the flyout menu.
5. Select Network Connection. Note your system status and select Change Network.
6. You may be notified to start Bluetooth—follow the on-screen instructions, otherwise touch Bluetooth LED Flashing
to continue.
7. Select your Wi-Fi network from the list.
8. Enter Password if asked, and touch Connect. A success message will appear.
9. Wait two minutes, then confirm onboarding success:
On the MyRedback app, check that data is refreshing every 20 seconds;
On the Portal, check that your system is online, and refreshing every 60 seconds.
10. If onboarding fails, try again, or contact Redback Customer Support for help.