Redback SI5000 - System Overview

Introduction
6 Owner’s Guide – Redback Smart Inverter – v1.4
Important safety instructions – please read
This document contains important safety instructions for products produced by Redback Technologies. Please read all the
instructions and cautionary markings on the product and on any accessories or additional equipment included in the
installation. Failure to follow these instructions could result in severe shock or possible electrocution. Always use extreme
caution to prevent accidents.
SYMBOL
DEFINITION
WARNING: LETHAL VOLTAGE INSIDE
Do not remove
any system cover unless qualified to do so.
Do not perform any servicing other than that specified in the maintenance instructions.
DANGER.
Risk of electrical shock. Proceed with caution.
WARNING: Burn Hazard.
External and internal parts may be hot. Do not remove covers during operation or touch any internal parts.
The
temperature of some parts may exceed 60°C during
operation. After shutdown, allow the inverter to cool for at
least 5 minutes before touching.
CAUTION: Hazard to Equipment
Only use components or accessories recommended or sold by Redback Technologies or its authorised agents.
Handle all parts
with care and follow instructions provided.
WARNING: Fire hazard
Do not keep combustible or flammable materials in the same room as the equipment. The Redback Smart
Inverter
contains relays and switches that are not ignition protected.
Ensure clearance
requirements are strictly enforced: Maintain 200mm of clear space around unit to ensure
unobstructed airflow
for convection cooling.
DELAY.
Wait specified time e.g., 10 minutes.
This symbol indicates the information provided is important for the
correct operation and or maintenance of the
equipment. Failure to follow the recommendations may result in annulment of the product warranty.
System overview