14
Problem Possible cause Solution
Seed is spoilt from the seed
tray.
Seeding slit too large.
Distance between the scraper
and the seeding roller is too
large.
The adjustment plate of the
seeding slit on the side is
leaking.
Readjust the seeding slit.
Set the scraper closer to the
seeding roller.
Tape up/glue.
The machine does not reach
the required depth.
Tractor tensioning is too low.
Ground is too hard.
Top rod is incorrectly
adjusted.
Too much dead leaves and
roots in the top layer of the
field.
Not enough weight.
Put drawing arms into a higher
hole.
Aerate/irrigate.
Correctly adjust the top rod.
Remove the dead leaves and
roots.
Add weight.
Drive wheel is slipping Ground is too wet.
Tyre pressure is too low.
Dose-measuring roller is dirty.
Chain drive is rigid.
Postpone the tilling.
Inflate.
Clean the dose-measuring roller.
Lubricate.
13.0 EU CERTIFICATE
We, Redexim BV, Utrechtseweg 127, 3702 AC Zeist, The Netherlands, declare entirely on
our own responsibility that the product
OVERSEEDER MODEL 1575/2075 WITH MACHINE NUMBER AS INDICATED ON THE
MACHINE AND IN THIS MANUAL,
to which this declaration refers, complies with stipulation of the 2006/42/EC machine
directive and is in conformity with the following standards: NEN-EN-ISO 12100 : 2010 NEN-
EN-ISO 13857 : 2008
Zeist, 01/10/09
A.C. Bos
Manager Operations & Logistics
Redexim Holland
To Next Page
Loading...
