3
!
SAFETY INSTRUCTIONS !
Fig. 1
The design of the Overseeder allows for safe use.
However, this is only possible if the user fully
observes the safety instructions given in this
manual.
Read and understand (Fig. 1) the manual before
starting to use the Overseeder.
Not using the machine as described in the manual
may lead to injury and/or damage to the
Overseeder.
(1) The Overseeder is solely intended for tilling lawns or areas where grass should
grow.
Any other use is considered to be incorrect use. The manufacturer does not
accept any liability with regard to damage resulting from incorrect use; all resulting
risks are the responsibility of the user.
Correct use also includes following the manufacturer’s instructions for use,
maintenance and repair.
Before using the Overseeder, inspect the area to be treated.
Remove any loose obstacles and avoid irregularities.
(2) The Overseeder was constructed according to the latest technological knowledge
and is safe to use.
Improper use, maintenance or repair of the machine may result in injury to both
the user and others. This should be avoided!
Always use the Overseeder in combination with the appropriate tractor as
described in the technical data.
(3) All persons whom the owner assigns to operate, maintain or repair the
Overseeder must read and completely understand the operating manual and in
particular the Safety Instructions section.
The user is responsible for a safe tractor/Overseeder combination. This unit
must be tested in terms of noise, safety and ease-of-use. In addition, user’s
instructions must be prepared.
(4) Before using the Overseeder, the user is obliged to inspect it for visible damage
and defects.
Any changes of the Overseeder (including its functioning) that may affect its
safety must be corrected immediately.
For safety reasons it is in principle forbidden to make changes in or additions to
the Overseeder (with the exception of those approved by the manufacturer).
If any modifications have been made to the Overseeder, the present CE
certificate becomes null and void and the person who made the modifications
should himself make sure a new CE certificate is granted.
To Next Page
Loading...
