Redexim BLECAVATOR 145

Questions and Answers

M
Matthew ShortAug 6, 2025
Why does my Redexim Farm Equipment machine vibrate?
- L
  Leah ThomasAug 6, 2025
  Your Redexim Farm Equipment machine may be vibrating due to several reasons: * There might be obstacles between the knives. If so, remove them. * The angles could be crossing the PTO differently; rotate the top rod to an acceptable angle. * The knives may not be mounted in a spiral pattern; ensure they are mounted correctly. * Incorrectly mounted or wrong knives may cause vibration; replace the knives or mount them with the sharp edge to the front. * Worn or broken knives can also cause this issue, so replace them if necessary. * A bent rotor can cause vibrations; straighten or replace it. * Wear and tear in the drive(s) may be the cause; check the drive(s).
M
Michelle NelsonAug 12, 2025
What to do if the rotor is blocked in my Redexim Farm Equipment?
- D
  David HallAug 12, 2025
  If the rotor of your Redexim Farm Equipment is blocked: * The subsoil might be too wet. Wait for better conditions. * There could be obstacles between the knives. Remove any obstacles. * The leveling bar might be too low. Adjust the leveling bar. * The rotor speed could be too low. Put the gearbox in a higher position. * The driving speed might be too high. Reduce the driving speed. * There may be too much overgrowth. Cut the overgrowth.
E
Elizabeth CrawfordAug 18, 2025
What to do if my Redexim Farm Equipment working depth is not achieved?
- J
  johnsonmatthewAug 19, 2025
  If your Redexim Farm Equipment is not achieving the desired working depth: * Ensure the rear roller is adjusted correctly. * If the subsoil is too hard, reduce the driving speed, put the gearbox in a lower position, or drive more passes. * If the driving speed is too high, reduce it.
E
Elizabeth JohnsonAug 25, 2025
What causes too coarse treatment of the soil with Redexim Farm Equipment?
- V
  Vincent AndersonAug 25, 2025
  If your Redexim Farm Equipment is treating the soil too coarsely: * The driving speed might be too high, so reduce it. * The subsoil might be too wet; wait for better conditions. * The leveling bar may be set too high; set the leveling bar lower. * The pin rack might be set too coarse; set the pin rack finer.
M
Melanie Barnes MDAug 30, 2025
How to fix too fine treatment of the soil with Redexim Farm Equipment?
- A
  Angela SteeleAug 30, 2025
  If your Redexim Farm Equipment is treating the soil too finely: * Increase the driving speed, as it may be too low. * Wait for better conditions if the underground is too dry. * Set the leveling bar higher if it is set too low. * Adjust the pin rack coarser if it is set too fine.