19
10.2. Putting the rear roller off centre
If required, the rear roller can be put off centre. You can slide the roller to the left or to the right so that
you overlap the part that is already treated.
Adjusting is done as follows (see Fig. 8):
Fig. 8
!! Switch off the tractor’s engine and PTO before descending !!
!! Make sure that the tractor and the machine cannot move uncontrolled !!
1. Loosen the two nuts (1) and the two bolts (2) a few turns.
2. Slide the roller to the required position by lifting the rear roller slightly using the two handgrips
(3).
3. Tighten the bolts (2) and nuts (1).
10.3. Adjusting the levelling bar
The levelling bar is used to obtain a nice looking, flat surface after treatment.
The levelling bar should be set to the required height, which depends on the conditions and
composition of the ground.
In general, a nice looking, even end-result is created if a small quantity of soil remains in front of the
bar during treatment.
To Next Page
Loading...
