18
10. TECHNICAL INFORMATION
Generally speaking, the Blecavator 145 / 210 is not a complicated machine. A number of technical
issues will be explained. If you still have questions, please contact your dealer who is always ready to
assist you.
10.1. Adjusting the working depth
The working depth can be adjusted by adjusting the rear roller as follows (see Fig. 7):
Fig. 7
!! Switch off the tractor’s engine before descending !!
!! Make sure that the tractor and the machine and PTO cannot move uncontrolled !!
1. Loosen the nuts (1) of the spindles (2) on both sides of the machine one whole turn.
2. Turn the roller to the required working depth using the spindles (2) on both sides of the
machine.
3. Tighten the nuts (1) of the spindles (2).
To Next Page
Loading...
