8. MACHINE SETTINGS
The Multi-Seeder has several options to change the setup op the machine.
8.1. ADJUSTING THE SPIKED ROLLERS
The spiked rollers make holes in the ground for the seeds to fall into. These rollers follow the
contours of the ground. Because of this a good result can be obtained even when the seed
bed is uneven. When seeding on very hard ground the rollers can have difficulty penetrating
the ground deep enough. To counter this, the rollers can be tilted so only the front roller
makes contact with the ground. Because the weight of the machine pushes on only the front
roller instead of two the holes will be deeper.
The following steps describe how the roller can be tilted (Figure 6):
1. Lift the machine of the ground
!! Make sure the tractor is secured in place and cannot start moving !!
!! Turn the tractor off before dismounting !!
2. Remove the lock pin, left and right.
3. Tilted the frame
4. Place the pin the upper hole. Make sure the lock pin is secured.
Figure 6
To Next Page
Loading...
