3. REMOVING THE MACHINE FROM THE PALLET
Perform the following actions to remove the machine from the pallet and place it horizontally
on the floor.
1. Attach a cable to the lifting points (1) on both sides of the machine (Figure 4).
ENSURE THAT THE CABLE / CRANE COULD LIFT AT LEAST 2X WEIGHT OF
THE MACHINE. (FOR WEIGHT SEE CHAPTER 1.0 TECHNICAL DATA)
2. Lift the machine, including the pallet, about 100 mm (4”) off the ground.
3. Remove the pallet by removing the bottom 3-point pins (2).
4. Pull the pallet away.
5. Lower the machine in a controlled and slow way until it is fully on the ground.
!! STAY AT A SAVE DISTANCE, THE MACHINE CAN SLIDE !!
!! NEVER CRAWL UNDER THE MACHINE !!
Figure 4
To Next Page
Loading...
