Redexim MULTI-SEEDER 1200 - 9 Troubleshooting

19
9. TROUBLESHOOTING
Problem
Possible cause
Solution
The machine does not
reach the required
depth.
The ground is to hard
Aerate/irrigate
Too little pressure on the front
roll
Set the machine so that it rests on
the front spiked roller only
Not enough weight on the
machine.
Mount extra weight on the
machine
Spikes are worn
Replace the spikes
The tractor does not
have enough traction
Soil is too wet
Set the sowing
Not enough weight on the
machine.
Mount extra weight on the
machine
There is no seed out of
the machine.
Too wet seed causing it to
stick
Use dry seed
The gearbox is in the wrong
position
Set the gearbox
The lever to control the seed
element valves is closed
Operate the lever to open the
valve
No seed in the hopper.
Controller whether there is
sufficient seed is in the hopper.
Fill if necessary.
There is too much seed
out of the machine.
The lever to control the seed
element valves is fully opened
Operate the lever to close the
valve