济南红帆科技有限公司
Redsail Tech Co., Ltd
h t t p : / / w w w . e a s y c u t . c n
mirrors and focus lens need to be removed from frame ， Wiping the same way ， after
wiping,install back as original.
(1) Gently wipe the lens, not be damaged surface coating；
(2) Wipe process should be gently，Prevent falls；
(3) Make sure to keep downward convex of focusing mirror when installation
。
6.2.4 Rail cleaning（Recommend cleaned once every two weeks, shutdown）
Rails, linear axis as one of the core components of the device ， Its function is to play a
guiding and supporting role
。
In order to ensure that the machine has a high precision
，
It
requires its guides, linear guide with high precision and good movement stability。during
operation ， because of the article will produce a lot of corrosive dust and fumes in the
processing
，
and These large quantities of smoke and dust deposited on the rail, linear shaft
surface，not only have a significant impact on the precision，but also will become pitting in
the surface of guide linear axis，Shorten equipment life 。 In order to make the machine
works properly and stable
，
ensure the quality of processed products
，
it should be do a a
careful routine maintenance work for guide, linear axis
(1) Prepare clean rail——Dry cotton cloth and lubricants 。 Engraving machine rail can be
separate into linear guide rail(rail and slide), roller guide (nylon wheels, bearings, eccentric
(2) Clean linear guides：Firstly, moves the laser head to the far right (or left)，Wipe clean with
a dry cloth until shiny，Coupled with a little oil，push the laser head slowly around a few
minutes
，
Allow oil can be evenly distributed
。
(3) Cleaning roller rail：The beam is moved to the inside，open the both side of the machine
cover，Wipe clean the place on both sides of the rail and the roller contact with a dry cloth，
Then move the beam
，
clean up the remaining places
，
Without oil
。
6.2.5 Screw and coupling fastening
Motion system after a long time work，the screws and coupling in Motion connection will
loose ,it will affect the stability of mechanical motion
，
so it need observe if there are any
abnormal sound or anomalies for transmission components during machine works,Identify
To Next Page
