Redsail M500 - Six Equipment Maintenance and Precautions; Ground Wire

M500 激 光 雕 刻 机 使 用 说 明 书
17
济南红帆科技有限公司
Redsail Tech Co., Ltd
h t t p : / / w w w . e a s y c u t . c n
problems in a timely manner and maintain strongly。In the same time after a long work，
should reinforce the screws individually by tools 。 The first reinforcement should be in
about a month after the devices working.
6.2.6 Optical inspection
laser engraving machine Optical system is reflected by the reflect mirror and focus lens
together to complete
，
Focus Lens shift problem does not exist in the optical path
，
But three
mirrors are fixed by the mechanical part，most Likely offset，It is recommended that users
should be check if each light path is normal before work。
6.3 Equipment Considerations
6.3.1First through the water before turning，during the working, it should be keeping check of the
circulation of water ， to ensure the water cycle normal in the laser tube,To protect the
normal use of the laser tube.
6.3.2 Follow the order of the machine switch：First open water pump (water ciller)when power
on，then open the power switch，Finally open laser switch。Off laser switch firstly when
power off
，
Then turn off the power switch
，
finally off the pump ( water chiller)
6.3.3 Controlling the temperature of water in the laser tube，Usually not more than 35 degrees，
When the machine runs out of in winter, let go the water in tube,prevent Laser frozen。
6.3.4 Clean machine
，
In particular lenses
，
Dirty lenses will affect the light reflection efficiency,
processing of samples, the lens itself life，Wipe the lenses gently use a cotton swab dipped
in alcohol, in case Scraped surface of the lens。
6.3.5 Do not place flammable items in Laser reflection region and the machine around
，
Do not
place reflective items inner platform.
6.3.6 During Process, the operator can not deserting machine, must always pay attention to the
work of the state machine
，
If meet unusual circumstances, please shut off immediately.
6.3.7The ground is very important, the machine must be completely grounded，The machine's
power must to be shared with a computer with a same power strip and the ground.