Redsail M500 - Water, Air Tube, and Air Pump Connections

M500 激 光 雕 刻 机 使 用 说 明 书
7
济南红帆科技有限公司
Redsail Tech Co., Ltd
h t t p : / / w w w . e a s y c u t . c n
(2) Please find the water pipes and air pipes in the packing box, follow the prompts of Figure 2,
connected to the rear port of the machine.
3.2.2 Annexes to the role:
：
(1) air pump role:
 Prevent generated dust into the gas nozzle when the machine is processing materials, pollution
Focus Lens .
 Blow away dust produced during processing, make the processing depth shading flatter.
 Prevent in the process of machine working, blew flammable objects produced.
(2) water pump role:
 Before the machine is working, it must ensure laser tube filled with recycled water, otherwise it
will burn laser tube, causing irreparable damage. When pass water, be sure to keep the water
clean
，
Dirty water will affect effect of laser tube light, reduce the laser tube life
(recommended to use purified water). Also note that the water temperature, water
temperature laser cutting machine at work should not exceed 35 ℃, the temperature is too
high will cause the laser tube is not working properly, serious or even burn out the laser
tube.In the north, using a laser cutting machine in the winter , the water temperature inside the
tank can not than 0 ℃. After the work is completed, the water must be drained laser tube to
prevent the cracking of the laser tube, water tank holding at least 3/4.
3.3 Ventilator and Ventilation duct connections.
（Figure 3）
1. ventilator 2. Power input plug (220V) 3. The device ventilation slots 4.220V output power
outlet 5. Air outlet 6. The vent pipe