Reechcraft Bronco - Section 2: Preparation & Inspection

Bronco by ReechCraft
10
2.1 Personnel Requirements
SECTION 2
PREPARATION & INSPECTION
This all-terrain scaffold is intended to be used as a personnel handling device and
must be operated and maintained by competent personnel only.
Anyone under the inuence of drugs, alcohol or are subjected to bouts of dizziness,
seizures or loss of physical control must not operate this all-terrain scaffold.
Operator Requirements
Before operating this all-terrain scaffold, the operator must read and comprehend
this manual.
The operator must be familiar with:
1. Use and limitations of the components of the all-terrain scaffold including
the specication requirements.
2. Instruction and warning decals on the all-terrain scaffold and in this manual.
3. Employer and government regulations.
4. Use of approved fall protection device (where applicable).
5. Sufcient mechanical aptitude and knowledge of the all-terrain scaffold to
recognize a component malfunction or a potential malfunction.
6. The safest means to operate the all-terrain scaffold where overhead and
ground hazards are present. These hazards include: overhead obstructions,
additional moving equipment, obstacles, depressions, drop-offs, etc.
7. A means to avoid unprotected electrical conductors.
8. The specic job requirements.
Operator Responsibilities
The exercise of good judgment, safety control, and caution in evaluating each
situation is the responsibility of the Operator. The Operator must stop using the
all-terrain scaffold in the event of a malfunction or other unsafe condition of the
all-terrain scaffold or job site.