Reechcraft Bronco - Safe Operation Practices

Bronco by ReechCraft
8
1.3 Operation
SECTION
1
SAFETY PRECAUTIONS
General
• Do not use the all-terrain scaffold for any purpose other than positioning
personnel, their tools, equipment and materials.
• Never operate an all-terrain scaffold that is not working properly. If a
malfunction occurs, contact ReechCraft.
• Unless in an emergency, do not allow personnel to tamper with the
all-terrain scaffold from the ground with personnel on the platform.
• The operator shall not mount the platform unless the bearing surface is
stationary and capable of supporting the intended load.
Fall Hazards
• Before operating the all-terrain scaffold, make sure the back leg is in the
proper position. Be sure the platform is properly placed on the all-terrain
scaffold unit before mounting.
• Keep both feet rmly positioned on the platform at all times. Never use
ladders, boxes, steps, planks or any other item on the platform to provide
additional height for greater reach.
• Always use extreme caution when mounting or dismounting the platform.
• Always maintain three points of contact with the all-terrain scaffold. “3 point
contact” means using two hands and one foot or two feet and one hand at
all times while mounting or dismounting the platform.
Tipping Hazards
• Be sure the bearing surface is solid, stationary and capable of supporting
the intended load.
• Before mounting the platform, ensure that all locking pins are fully engaged.
• Check the back leg label to be sure the horizontal line is parallel to the
ground and the vertical line is plumb.