www.reechcraft.com/bronco 888-600-6160
17
SECTION
3
ALL-TERRAIN SCAFFOLD OPERATION
3.4 Weight Distribution
Note Label and Angle Position
Note Label and Angle Position
Note the decal on the back leg and ensure that the horizontal line is parallel to the
ground and the vertical line is plumb (See Figure 3-2).
NOTE: This label is located on the side of the middle leg of the Bronco and must be followed to ensure
proper set-up!
Figure 3-2 Caution Label
3.5 Platform Configuration
Wall Surface
The Bronco is angled for easy access
and proper weight distribution.
Figure 3-3 Broncos and Platform
Ensure that the Bronco is angled like the diagrams below for easy plank access and
proper weight distribution. (See Figure 3-3).
NOTE: Do not overload Bronco. Duty rating is 300 lbs per Bronco.
To Next Page
Loading...
