Reechcraft Bronco - Daily Walk-Around Inspection

Bronco by ReechCraft
12
SECTION
2
PREPARATION & INSPECTION
The following table outlines the periodic all-terrain scaffold inspection and maintenance
recommended by ReechCraft. Consult local regulations for further requirements.
The frequency of inspections and required maintenance must be increased if the
all-terrain scaffold is exposed to harsh conditions, increased use or if the
all-terrain scaffold is used in a severe manner.
Table 2-1 Inspection and Maintenance
TYPE FREQUENCY
PRIMARY
RESPONSIBILITY
SERVICE
QUALIFICATION REFERENCE
Pre-start
Inspection
Before starting
each day or at shift
change
Operator User or Operator
Operator’s and
Safety Manual
Frequent
Inspection
In service or out of
service for 3 mo.
Or purchased used
Owner, Dealer or
User
User or Operator
Operator’s and
Safety Manual
Annual
Inspection
Every 12 Months
Owner, Dealer or
User
User or Operator
Operator’s and
Safety Manual
Replacement
When locking
pins are worn or
damaged
Owner, Dealer or
User
User or Operator
Operator’s and
Safety Manual
NOTE: Use this manual to perform inspections
2.3 Daily Walk-Around Inspection
Begin the Daily Walk-Around Inspection starting at item one (1) as noted on the
diagram Figure 2-1. Continue around the all-terrain scaffold checking each item in
sequence for the conditions listed in the following check list.