www.reechcraft.com/bronco 888-600-6160
11
2.2 Preparation, Inspection & Maintenance
SECTION
2
PREPARATION & INSPECTION
Pre-Start Inspection
The Pre-Start Inspection should include each of the following:
1. Cleanliness - Check all surfaces for debris or foreign objects.
2. Decals - Check for cleanliness and legibility. Make sure none of the
decals are missing. Make sure all illegible decals are cleaned or replaced.
(Reference Section 5.2 Decal Contents and Location)
3. Safety, Service - Make sure a copy of the Operator’s and Safety
manual is accessible and stored in a safe place.
4. Set-Up - Make sure the all-terrain scaffold is set-up in accordance with
Section 3.4.
5. Walk-Around Inspection - Refer to Section 2.3.
6. Function Check - Once the Walk-Around Inspection is complete, perform
a function check of all systems in an area free of all over-head or ground
level obstructions. Refer to Section 2.4 for additional information.
To Next Page
Loading...
