Bronco by ReechCraft
24
SECTION
6
SERVICE & MAINTENANCE
6.2 Preparation, Inspection & Maintenance
General
This section provides the necessary information needed by those personnel that are
responsible to place the all-terrain scaffold in operational readiness and maintain its
safe operating condition. To ensure maximum service life and safe operation, be
sure that all inspections and maintenance have been completed before placing the
all-terrain scaffold into service.
Preparation, Inspection & Maintenance
Table 2-1 outlines the periodic all-terrain scaffold inspection and maintenance
recommended by ReechCraft. Consult your local, regional or national regulations for
further requirements.
NOTE: The frequency of inspections must increase as environment and frequency of use requires.
Pre-Start Inspection
It is the operators responsibility to perform a Pre-Start Inspection of the all-terrain
scaffold prior to use. Reference Section 2 in this manual for Pre-Start Inspection
procedures.
This manual must be read and understood in its entirety prior to performing a
Pre-Start Inspection.
Frequent and Pre-Delivery Inspection
The Frequent Inspection and Pre-Delivery Inspection shall be performed by a
competent person or a qualied mechanic.
The Frequent Inspection and Pre-Delivery Inspection procedures are performed in
the same way but at different times. The Pre-Delivery Inspection shall be performed
prior to each sale, lease, or rental delivery. The Frequent Inspection shall be
performed on each all-terrain scaffold in service for 3 months; out of service for more
than 3 months; or when purchased used. The frequency of this inspection must
increase as environment and frequency of use requires.
Reference this manual for service and maintenance procedures.
To Next Page
Loading...
