Reechcraft Bronco - All-Terrain Scaffold Set-Up; Getting Started

Bronco by ReechCraft
16
NOTE: For the purposes of this section, it is assumed that the all-terrain scaffold is in it’s fully stowed
configuration.
Getting Started
1. Unfold the Bronco by
pulling out the rear leg
and pressing down on
the spreader to lock the
leg into position.
2. Push down on the
locking pin, rotate the
bottom of the leg and
extend to the desired
length. Twist the leg
to spring the pin into
the hole. Be sure the
locking pin is fully
engaged.
3. To ensure proper setup,
consult the rear leg
decal.
SECTION
3
ALL-TERRAIN SCAFFOLD OPERATION
3.3 All-Terrain Scaffold Set-Up