Reflex Variomat - Page 23

Controller messages
Master/Slave Operation — 24.09.2015 English — 23
A selection of solutions for the error is displayed.
4. Check the device according to the selection.
Current messages
29 Communication
Remedy:
– Check the configuration settings
– Check the cable to the module
– If necessary, replace the module
2.9 bar 0 %
You can acknowledge the error message as soon as the error has
been eliminated.
5. Press "OK“.
Current messages
29 Communication
Remedy:
– Check the configuration settings
– Check the cable to the module
– If necessary, replace the module
The error has been eliminated and can
be acknowledged.
2.9 bar 0 %
OK