Need help?Do you have a question about the Reflex Variomat Basic and is the answer not in the manual?
General| Maximum operating temperature | 70 °C |
|---|---|
| Category | Heating |
| Description | Diaphragm expansion tank for closed heating systems |
| Volume | 8 - 1000 l |
| Connection | Threaded connection |
| Material | Steel |
| Type | Diaphragm expansion tank |
Explains symbols and signal words used in the manual.
Specifies the qualifications needed for operating personnel.
Details required personal protective equipment for safe operation.
Describes the primary application and suitable system types for the device.
Lists applications and conditions where the device should not be used.
Provides a visual diagram of the device components with labels.
Details how to identify the device and its components.
Explains the information found on the device's nameplate.
Provides technical specifications for the I/O module.
Details configuration options for the I/O module.
Explains how to configure RS-485 network terminators.
Presents technical specifications for the device's control unit.
Lists technical specifications and dimensions for the device's tanks.
Specifies prerequisites and conditions for installing the device.
Outlines the necessary steps before beginning the installation process.
Details the step-by-step process for executing the installation.
Instructions on how to correctly position the device components.
Steps for installing accessories onto the tanks.
Guidance on how to install the primary and secondary tanks correctly.
Details how to connect the device to the main facility system.
Explains the basic operation of switching and make-up functions.
Describes the operation in a single-tank system configuration.
Details operation within a district heating substation setup.
Provides a visual representation of the device's terminal connections.
Lists the prerequisites that must be met before commissioning the device.
Explains how operating pressures affect switching points.
Guides users on how to adjust the controller's initial setup parameters.
Instructions for filling the primary and secondary tanks with water.
Provides instructions for safely venting the pump.
Guides on setting system-specific values via the customer menu.
Describes the device's operation in automatic mode and its monitored functions.
Guides on using manual mode for testing and maintenance tasks.
Explains how to put the device into stop mode for maintenance.
Details how to configure the device for summer operation to save energy.
Provides precautions for restarting the device after a standstill.
Describes the components and functions of the device's operator panel.
Explains how to adjust controller settings via the customer menu.
Explains how to view and interpret error messages and alarms.
Provides a summary of regular maintenance tasks and intervals.
Instructions for cleaning the dirt trap component.
Instructions for cleaning the primary and secondary tanks.
Details the procedure for checking and verifying device switching points.
Outlines general inspection requirements for pressure equipment.
Specifies inspection requirements before initial device startup.
Details recommended intervals for device inspections.
Covers inspection requirements for pressure-bearing parts.
To Next Page