16
troubleshooting
• Check under the bed base to verify that the wired connections are secure and that there are no cords or bedding
obstructing the movement of the base.
• Check to ensure the LED light is illuminated on the control box. If there is no light, verify that the input and power
cords are properly connected.
• Unplug the base for 60 seconds to reset the electronic components.
• Plug bed base into a dierent electrical outlet, or test current outlet with another working appliance (a grounded,
electrical surge protector is recommended).
ADJUSTABLE BASE
REMOTE CONTROL
• Ensure that the remote batteries are properly installed and do not need replacing.
• Ensure Child Lock feature is not enabled. See page 10 for more information.
• Ensure that the remote control is paired to the base.
If one or more functions on the bed base have stopped operating:
If issue is not resolved by following the instructions above, locate serial number on warranty card or
back of remote and call Customer Service: 1-800-268-4414
To Next Page
Loading...