Reflexion Arc - Remote Control Pairing and Features; Pairing Procedure; Child Lock Activation and Deactivation

10
remote control pairing
The original remote that comes in the box is already paired to the adjustable base. No further action is
required. In the event that the remote is not paired with the base, follow the steps below.
PAIR
Button
Test all remote functions. If the remote buttons do not
impact the adjustable base movements, please repeat the
process again or call customer service: 1-800-268-4414
STEP 1
STEP 2
STEP 3
Remove rear cover of the remote control by sliding it down
to expose the PAIR button. Unplug the Power Cord from
your power outlet. Wait 1 minute, then plug it back in to your
power outlet. Perform Step 2 within 10 seconds, while the
control box light is flashing.
Power
Cord
Power Supply
Press and hold the PAIR button on the
back of the remote. The PAIR button
will illuminate and start to flash. When
the PAIR button stops flashing, the LED
light on the control box will stop flashing.
Release the PAIR button.
Press and hold HEAD UP & FOOT UP buttons
together for three (3) seconds.
The remote backlight will flash. When the
backlight goes away, the remote is now in
Child Lock.
Activate Child Lock
Deactivate Child Lock
STEP 1
STEP 1
Press and hold HEAD DOWN & FOOT DOWN
buttons together for three (3) seconds.
Press and hold HEAD UP & FOOT UP buttons
together for three (3) seconds.
The remote backlight will flash. When the
backlight goes away, the remote is no longer in
Child Lock.
STEP 2