7
STEP 7
STEP 8
STEP 9
Carefully flip the base over on to its legs. Important: Two
people are required to move the bed base. Do not drag
across the floor. Do not rest frame on its side, excessive
pressure may damage the legs.
Plug the power cord into a power source. A surge protector
is recommended.
Ensure batteries are correctly installed in the back of the
remote.
Quickly test functions to verify proper setup before placing
mattress on base. Return the base to a flat position before
placing the mattress on top.
Setup is now complete! Test all functions on remote.
installation guide
STEP 10
For customer service call: 1-800-268-4414
To install the mattress retainer bar, insert each end of the bar
into the holes at the foot of the platform.
To Next Page
Loading...
