6 ST 1, STR 1
The EA ST 1, STR 1 are delivered in solid packages guaranteeing resistance in accordance with EN 60 654
(IEC 60 654-1 and IEC 60 654-3).
Package is a box. Products in boxes is possible to load on the pallets (pallet is returnable). On the outer
side of the package is stated:
• manufacturer label,
• name and type of product,
• number of pieces,
• other data – notices and stickers.
The forwarder is obliged to secure packed products, loaded on transportation means, against self-motion;
if open transportation means are used, to secure their protection against atmospheric precipitations and
splashing water. Displacement and securing of products in transportation means must provide their stable
position, exclude the possibility of their inter-collision and their collision with the vehicle walls.
They can be transported in unheated and not airtight areas of transport means with effects in range:
temperature: -25°C up to +70°C (a strange version – 45 ° C up to + 45 ° C)
humidity: 5 up to 100%, with maximal content of water 0.029 kg/kg per kg of dry air
barometric pressure: 86kPa up to 108kPa
After receiving EA check whether during transport or storage the actuator was not damaged.
Compare also whether the parameters on their nameplates are in accordance with accompanying
documentation or the Contract. If any discrepancy or fault occur inform immediately your supplier.
If the actuators and accessories are not immediately installed, they have to be stored in dry, well-
ventilated sheltered roos, protected against dirt, dust, soil humidity (with placing onto shelves or onto
pallets), chemical impacts and encroachment, at ambient temperature from -10°C up to +60 °C and
relative humidity max. 80 %.
It is not allowed to store EA in the open air or in areas not protected against direct impact of
climate!
If any scratch on the surface finishing occurs remove it immediately - you protect this way actuators against
damaging with corrosion.
If storing takes longer than 1 year, it is necessary to inspect lubrication fillings before putting EA into operation.
Assembled EA, but not put into operation is necessary to protect by the equivalent method as during
storage (for example suitable protective cover).
After assembly to the armature in free and wet areas, or in areas with temperature changes, connect
without delay heating resistor – thus preventing damages caused by corrosion from liquefied water in the control
area.
Excessive preserving grease remove just before putting EA into operation.
1.8 Appreciation of the product and packing
The product and its package are made of recycling materials. Do not throw the single parts of the
package and of the product after their life but sort them according to instructions in corresponding
executives or regulations of environment protection, and allow their recycling.
The product and its packing are not a source of any environment pollution or contamination and do
not contain any dangerous waste.
!
To Next Page
Loading...
Need help?
General
