Capacity Plate_________________________________
Close to the helm on Regal boats up to 26’ in length is a capacity plate.
This plate represents manufacturers who participate in the National
Marine Manufacturer’s Association small boat certifi cation program.
A similar yacht certifi cation plate for boats over 26’ covers many of
the same guidelines and others from ABYC into the yacht program.
Your boat has been certifi ed by NMMA approved inspectors to be
in compliance with their system guidelines along with federal safety
regulations. The driver of the craft must read the plate information
before operating the vessel. The plate is located at the helm, and an
image can also be found on the safety aboard chapter.
The capacity plate data applies under normal conditions. BE SURE
TO READ AND ABIDE BY THE CAPACITY LIMITS.
REMEMBER, THE BOAT OPERATOR IS RESPONSIBLE
FOR THE VESSEL AND PASSENGERS.
Note the following typical capacity plate information below:
The plate states the maximum number of persons allowed
on the boat, or an equivalent weight regardless of the
number of passengers
The total weight of persons, gear, and other items under
normal conditions that the boat is capable of carrying.
Overloading, improper loading, and weight distribution are
well documented causes of accidents. Provide for an extra
margin of safety in rough sea conditions.
INT-14
•
•
•
To Next Page
Loading...
