Regal 1900 - Drain Plug

DRAIN PLUG
Your boat is equipped with a drain plug centrally located on the
transom below deck level. Make sure it is installed tightly before
launching. Tighten with a wrench. Do not use your fi ngers alone to
tighten it. After your outing, while the boat is angled on the ramp,
remove the drain plug to eliminate any bilge water accumulation. If
the water stream is diminished, check for foreign objects stuck in the
drain hole. Pull the drain plug if dry storing the boat for extended
periods, especially in colder climates.
Refer to the vessel operation chapter for pre-departure use. Refer to
the storage and winterization chapter for storage directions. Refer to
the trailering section for pre-launch and post-trip use.
!
WARNING
TO PREVENT THE VESSEL FROM SINKING, INSTALL THE DRAIN
PLUG.
Drain Plug Warning
TIGHTEN - CLOCKWISE
Drain Plug Diagram
6-20
Chapter 6