Operation In “Bow Down” Position_______________
The “bow down” or “in” position is normally used for acceleration
onto a plane, operating at slow planning speeds, and running against
a choppy wave condition. It is also used when pulling water skiers,
tubers, knee boarders, etc. The boat’s bow will want to go deeper into
the water in this position. If the boat is operated at high speed and/
or against high waves, the bow of the boat will plow into the water.
DN
UP
TRI
M
Trim Down Gauge
Boat In “Bow Down” Position
Operation In “Level” Position____________________
In normal running conditions, distribute passengers and gear so the
boat is level. At or below cruising speeds, trim the vessel for optimum
performance. The trim gauge will normally indicate a near center
mark. This position will also enhance running visibility and overall
stability. Again, each outing provides different wave, load, and running
conditions. Be prepared to make trim adjustments as needed.
DN
UP
TRI
M
Trim Level Gauge
Boat In “Level” Position
5-18
Chapter 5
To Next Page
Loading...
