6-27
Equipment Operation
The 16 PLUS (priority) Channel
The 16 Plus channel has been preset to channel 16 prior to shipment
from the factory, but the 16 Plus channel can be changed to another
number, the the exception of all weather channels.
1) Press the up or down key to select the desired channel. Then press
and hold the 16 Plus key for three seconds. An audible beep tone will
confirm that the selected channel is stored in memory as the 16 Plus
channel.
2) To reselect channel 16 as the 16 PLUS channel, repeat step 1 for
channel 16.
Channel Memory
The Ray 48 can store into memory all U.S. or International channels.
The stored channels will be scanned during Memory Scan Mode.
1) Channel memory. To put a channel onto memory, select the channel
to be stored with the up or down arrows. Push and hold the SCAN
key for approximately two seconds until a beep is heard and “MEM”
is displayed on the LCD. This procedure can be repeated for all U.S or
International channels.
2) Memory clear. To clear a channel from memory, select the channel
to be cleared with the up or down arrows. Push and hold the “SCAN”
key for approximately two seconds until a “beep” is heard and “MEM”
disappears from the LCD.
Scan Modes
1) All-Scan Mode
If no channels are stored in memory, when the SCAN key is pressed
once, “SCAN” will begin to flash on the LCD. In three seconds, if no
other keys are pressed, the radio will begin scanning all channels
( except weather channels) as long as no signal is received. If a signal
is received, the scan will stop and monitor the receiving channel.If
the signal is lost for 5 seconds, the radio will resume scanning.
6-27
Equipment Operation
The 16 PLUS (priority) Channel
The 16 Plus channel has been preset to channel 16 prior to shipment
from the factory, but the 16 Plus channel can be changed to another
number, the the exception of all weather channels.
1) Press the up or down key to select the desired channel. Then press
and hold the 16 Plus key for three seconds. An audible beep tone will
confirm that the selected channel is stored in memory as the 16 Plus
channel.
2) To reselect channel 16 as the 16 PLUS channel, repeat step 1 for
channel 16.
Channel Memory
The Ray 48 can store into memory all U.S. or International channels.
The stored channels will be scanned during Memory Scan Mode.
1) Channel memory. To put a channel onto memory, select the channel
to be stored with the up or down arrows. Push and hold the SCAN
key for approximately two seconds until a beep is heard and “MEM”
is displayed on the LCD. This procedure can be repeated for all U.S or
International channels.
2) Memory clear. To clear a channel from memory, select the channel
to be cleared with the up or down arrows. Push and hold the “SCAN”
key for approximately two seconds until a “beep” is heard and “MEM”
disappears from the LCD.
Scan Modes
1) All-Scan Mode
If no channels are stored in memory, when the SCAN key is pressed
once, “SCAN” will begin to flash on the LCD. In three seconds, if no
other keys are pressed, the radio will begin scanning all channels
( except weather channels) as long as no signal is received. If a signal
is received, the scan will stop and monitor the receiving channel.If
the signal is lost for 5 seconds, the radio will resume scanning.
To Next Page
