CHAPTER 6
6-28
If the scan has stopped on a received signal, you may resume scanning
by pressing the SCAN key. To cancel the scan mode, press the SCAN
key once while the radio is scanning.
2) Memory Scan Mode
If one or more channels are stored in memory, when the SCAN key is
pressed “SCAN” and “MEM” will begin flashing simultaneously on
the LCD. If no other key is pressed, the radio will begin scanning all
channels in memory in three seconds. As with All-Scan, if a signal is
received, the scan will stop on the receiving channel until the signal
is lost for five seconds or the SCAN key is pressed. To cancel memory
scan, press the SCAN key while the radio is scanning.
If you have one or more channels in memory and want to initiate All-
Scan, perform the following:
Press the SCAN key. “SCAN” and “MEM” will flash on the LCD.
Press the SCAN key again within three seconds and “MEM” will
disappear from the LCD leaving only “SCAN” flashing. All-Scan will
begin in three seconds if no other key is pressed.
Master Reset
To preform a master reset, press and hold the 16 PLUS key while
turning the unit on. This feature clears all channels from memory and
programs the 16 PLUS feature back to channel 16.
Monitor Mode
Before entering the Monitor Mode you must first select the WX
channel you wish to monitor for the weather alert tone. Next, you
must select a working channel to be monitored for traffic.
1) Press WT/INT, then scroll to the desired weather channel with
the arrow keys.
2) Press the 16 PLUS key to exit the weather band and return to
normal mode.
3) Use the arrow keys to select the desired working channel.
4) Press the MON/1/25 key to begin monitor mode. Press the MON/
1/25 key again to cancel Monitor Mode.
CHAPTER 6
6-28
If the scan has stopped on a received signal, you may resume scanning
by pressing the SCAN key. To cancel the scan mode, press the SCAN
key once while the radio is scanning.
2) Memory Scan Mode
If one or more channels are stored in memory, when the SCAN key is
pressed “SCAN” and “MEM” will begin flashing simultaneously on
the LCD. If no other key is pressed, the radio will begin scanning all
channels in memory in three seconds. As with All-Scan, if a signal is
received, the scan will stop on the receiving channel until the signal
is lost for five seconds or the SCAN key is pressed. To cancel memory
scan, press the SCAN key while the radio is scanning.
If you have one or more channels in memory and want to initiate All-
Scan, perform the following:
Press the SCAN key. “SCAN” and “MEM” will flash on the LCD.
Press the SCAN key again within three seconds and “MEM” will
disappear from the LCD leaving only “SCAN” flashing. All-Scan will
begin in three seconds if no other key is pressed.
Master Reset
To preform a master reset, press and hold the 16 PLUS key while
turning the unit on. This feature clears all channels from memory and
programs the 16 PLUS feature back to channel 16.
Monitor Mode
Before entering the Monitor Mode you must first select the WX
channel you wish to monitor for the weather alert tone. Next, you
must select a working channel to be monitored for traffic.
1) Press WT/INT, then scroll to the desired weather channel with
the arrow keys.
2) Press the 16 PLUS key to exit the weather band and return to
normal mode.
3) Use the arrow keys to select the desired working channel.
4) Press the MON/1/25 key to begin monitor mode. Press the MON/
1/25 key again to cancel Monitor Mode.
To Next Page
