Cosmetic Care & Maintenance
7-19
Do not remove the spring and ball assembly in theanti-siphon valve.
It can be cleaned with compressed air. Should the component be faulty
(normally a fuel surge problem at mid to high speed ranges) replace it.
Check the fuel fill pipe hose connection at the deck. Normally, there is
an access plate which can be removed for inspection. Make sure the
black ground wire is tightly secured. For further information, contact
your closest Regal dealer or marine professional.
TYPICAL
WATER
PUMP
FILTER
FEED HOSE
Chemical Toilet/ Pump Out Fittings
This self-contained unit requires periodic rinsing with soap and water.
Keep the unit flushed out as needed.
Vessels with the optional pump out fitting need to run fresh water
through the hose to keep debris from clinging to the hose inside
surfaces after each pump out.
Fresh Water System
Inspect the fresh water
system hoses and fittings
periodically. A sign of a
water leak is the pressure
water pump running
intermittently with the
faucet off. There is a fresh
water filter located on the
pressure water pump. Clean
the element of debris and
deposits as needed.
Reassemble and perform a
system leak check.For
information purposes ther
e is a pressure pump cut-out switch mounted on the water pump. It
controls the water system line pressure. When the system reaches
normal pressure the switch cuts out until a water demand resumes.
Cosmetic Care & Maintenance
7-19
Do not remove the spring and ball assembly in theanti-siphon valve.
It can be cleaned with compressed air. Should the component be faulty
(normally a fuel surge problem at mid to high speed ranges) replace it.
Check the fuel fill pipe hose connection at the deck. Normally, there is
an access plate which can be removed for inspection. Make sure the
black ground wire is tightly secured. For further information, contact
your closest Regal dealer or marine professional.
TYPICAL
WATER
PUMP
FILTER
FEED HOSE
Chemical Toilet/ Pump Out Fittings
This self-contained unit requires periodic rinsing with soap and water.
Keep the unit flushed out as needed.
Vessels with the optional pump out fitting need to run fresh water
through the hose to keep debris from clinging to the hose inside
surfaces after each pump out.
Fresh Water System
Inspect the fresh water
system hoses and fittings
periodically. A sign of a
water leak is the pressure
water pump running
intermittently with the
faucet off. There is a fresh
water filter located on the
pressure water pump. Clean
the element of debris and
deposits as needed.
Reassemble and perform a
system leak check.For
information purposes ther
e is a pressure pump cut-out switch mounted on the water pump. It
controls the water system line pressure. When the system reaches
normal pressure the switch cuts out until a water demand resumes.
To Next Page
Loading...
