CHAPTER 4
4-6
Docking Lights
This switch controls the hull docking lights. They are very useful for
night maneuvering and docking.
Engine Hatch
This switch controls the engine hatch used on selected models. It
supplies power to a hydraulic ram which opens the hatch. Be sure all
persons and objects are clear of the engine hatch area and before
activating the switch. Keep an “eye” on the engine hatch while it is
opening or closing.
Accessory (Acc)
This switch controls any after market accessories installed on the boat.
Make sure any added equipment is matched to the breaker protecting
the circuit.
As part of the direct current circuitry the engine features a breaker
with a reset button. This breaker protects the engine wiring from
overloads. Refer to the engine owner’s manual for the breaker location
and operation.
In addition, there are dash breakers protecting the individual switches.
If they “pop” due to an overload, they can be reset by pressing the
breaker reset. TheDC breaker sizes are listed. Replace a breaker with
the identical capacity only! Where fuses are used replace with the same
amperage and type.
Following is a DC breaker and or fuse listing for your boat.
DC Circuit Protection
Windlass
This switch controls the optional anchor windlass.
CHAPTER 4
4-6
Docking Lights
This switch controls the hull docking lights. They are very useful for
night maneuvering and docking.
Engine Hatch
This switch controls the engine hatch used on selected models. It
supplies power to a hydraulic ram which opens the hatch. Be sure all
persons and objects are clear of the engine hatch area and before
activating the switch. Keep an “eye” on the engine hatch while it is
opening or closing.
Accessory (Acc)
This switch controls any after market accessories installed on the boat.
Make sure any added equipment is matched to the breaker protecting
the circuit.
As part of the direct current circuitry the engine features a breaker
with a reset button. This breaker protects the engine wiring from
overloads. Refer to the engine owner’s manual for the breaker location
and operation.
In addition, there are dash breakers protecting the individual switches.
If they “pop” due to an overload, they can be reset by pressing the
breaker reset. TheDC breaker sizes are listed. Replace a breaker with
the identical capacity only! Where fuses are used replace with the same
amperage and type.
Following is a DC breaker and or fuse listing for your boat.
DC Circuit Protection
Windlass
This switch controls the optional anchor windlass.
To Next Page
Loading...
