CHAPTER 6
6-30
If equipped, the pressurized water system needs to be initially fi lled
to operate properly.
1. Unscrew the “water fi ll” deck fi tting. Fill the fresh water tank with
approximately 10 gallons of fresh water with a suitable container or
hose. Make sure the water is safe for drinking.
2. Find the helm fresh water pump switch and energize to the “on”
position. Pressurized water tank will fi ll entire system with fresh
water.
3. Open the faucet to allow any air to escape. Close the faucet when
there is a steady stream of water without air. You will hear the
pressure switch shut off the pump indicating the system is full.
4. If equipped with a cold water transom shower and/or bow
washdown repeat step #3.
5. After these initial procedures, “top” the system off with fresh
water.
6. Check for system leaks as evidenced by the pressure water pump
recycling even though no water is being used from the faucet.
7. It is a good idea to turn “off ” the fresh water pump switch after
each use.
AVOID PRESSURE PUMP BURN OUT!
DO NOT ACTIVATE THE FRESH WATER
SYSTEM WITH THE WATER TANK EMPTY.
To Next Page
Loading...
