CHAPTER 6
6-36
Seating/Cabin-Berth Conversion
The cabin seating serves a
dual function. It provides
dinette seating with the
optional cockpit table.
Insert the leg into the
cabin receiver and insert
the table into the leg top.
The hatch provides cabin
cross ventilation. See the
illustration.
The cabin can be converted to a berth. There are detented scallops
in the cabin liner to accept a set of support bars. Under the middle
starboard cushion 3 berth support bars are stored. Follow these steps
to set up the berth once the bars are located.
1. Pull the port aft backrest cushion up to release the cushion from
its holder.
This cushion will serve as one of the berth fi llers.
2. Pull the starboard backrest cushion up to release the cushion from
its holder. This cushion will be used as the other berth fi ller.
3. Insert 1 of the 2 short support bars in the forward most liner
detent.
4. Insert the other short support bar in the next liner detent.
5. Place the longer support bar diagonally from the port aft detent to
the starboard aft detent.
6. Place the port aft backrest on the support bars with the angle aft.
7. Place the starboard backrest cushion on the support bar with the
angle aft which completes the berth conversion.
To Next Page
Loading...
