11
Equipment Operation
1. Make sure the A/C seacock is open. The handle should
be in line with the seacock.
2. Activate the A/C breaker at the ship’s distribution
panel.
3. Turn the system on at the control pad.
4. Check for a steady stream of water at the air condi-
tioning hull through hull fitting.
5. Refer to the troubleshooting guide should the unit not
be operating properly..
Note: Do not turn the unit off and immediately turn it
back on. Allow at least 30 seconds for refrigerant pres-
sure equalization.
To Next Page
