11
Systems
Shower Pump
The shower pump 5 amp fuse protects the sump pump
located under the main cabin floor. Look for loose
connections or debris caught in the pump grate if the
fuse “blows”. Replace the fuse with the correct amperage
and type.
Tank Monitor
This 2.5 amp fuse controls the fresh and waste water tank
monitor gauge. In the “on” position the level monitor
panel can be activated to determine their respective
system levels.
CO Detect
This 2.5 amp fuse located at the D.C. distribution panel
protects the 12 volt CO detectors in the aft and forward
cabins. Should there be an overload on the circuit the
fuse will “blow”. Determine the cause of any overload
before replacing the CO fuse. When the fuse blows you
probably will hear the CO detectors audible alarm warning
indicating protection is no longer available and the
detector is running off battery backup battery cells located
in the CO detector itself.
To Next Page
Loading...
