1. Introduction
1.1 Foreword
Dear Customer
Congratulations, you have purchased a REHM TIG / Stick-electrode
welding unit, and therefore a German branded appliance. Thank you for
the confidence you have shown in our quality product.
Only components of the highest quality are used in the development and
production of REHM welding units. In order to ensure a high service life
that can be used under arduous working conditions, only components that
satisfy the REHM stringent quality control requirements are used in our
production. The TIGER range of welding units have been developed and
designed in accordance with the current valid recognised technical safety
regulations. All of the relevant statutory provisions have been observed
and incorporated; confirmation of this is given through the CE mark and
the Declaration of Conformity.
REHM welding units are manufactured in Germany and bear the
corresponding quality indicator "Made in Germany".
REHM endeavours to respond quickly to technological progress in the
interests of the customer. We reserve the right to change the design of
these welding units from time to time, and without notice in order to
ensure compatibility with the current state of the art technical
requirements.
To Next Page