Doc ID: 191-7913A
8. Loosely tighten the screws, then use the T-25 Torx bit
and torque wrench to tighten the screws in a star pattern
to 55 in-lb (6 N-m).
9. Remove the OE cover gasket from the OE clutch cover
and install it onto the new Rekluse clutch cover.
10. Install the Rekluse clutch cover, then lightly tightening
the cover bolts in a star pattern. Tighten bolts in small
increments before torqueing the cover bolts to OE
specifications.
NOTE: If your bike has an oil plug, transfer the OE oil
plug to the new Rekluse clutch cover.
pressure plate
flat side up
To Next Page
Loading...
