Doc ID: 191-7913A
SLAVE CYLINDER INSTALLATION
Installing the new Rekluse slave cylinder takes several
steps. Please read the entire section before beginning the
process to ensure you have the right equipment and clutch
fluid needed for the replacement. Rekluse recommends
wearing gloves and safety glasses for the install.
During the bleed and assembly,
note that there is a small ball
bearing installed in the slave piston
with a small amount of grease.
When installing the Rekluse slave
cylinder, make sure the ball is in
place and has not come loose.
Step 1: Bleed the new slave cylinder
This step prepares the new slave cylinder for installation.
Bleed the cylinder on a workbench or an area away from the
bike.
1. Using a 4 mm hex key, turn the adjuster screw
counterclockwise so that the top O-ring is visible under
the adjuster screw.
To Next Page
Loading...
