Doc ID: 191-7913A
4. With the bike idling in first gear,
slowly apply throttle to begin
moving.
5. Without using the clutch lever,
accelerate moderately to
approximately 5,000 RPM to fully
lock up the clutch and come to a
complete stop. Repeat 10 times.
NOTE: If the engine wants to stall or
the creep is excessive, the idle may
be too high or the installed gap may
be too small. Make necessary
adjustments before proceeding.
10 roll-on starts
6. Without using the clutch lever, start
in 2
nd
gear, then accelerate
moderately to approximately 5,000
RPM and come to a complete stop.
Repeat 10 times.
10 roll-on starts
To Next Page
Loading...
