51
EMC Compatibility
USER GUIDE
TECHNICAL SPECIFICATIONS
MACH-PROCOM
™
/MACH-PROWEBCOM
™
2007 − 2015 Reliable Controls
®
Corporation. All rights reserved.
EMC COMPATIBILITY
Light Industrial EMC Compatibility Draft Report Rev 1.0
Reliable Controls - EB-Con EBX
Section III: Report of Measurements per FCC CFR47 Part 15/B
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna,
• Increase the separation between the equipment and receiver,
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected, and
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules and ICES 03.
Changes or modifications to this equipment, not expressly approved by the manufacturer,
could void the user's authority to operate the equipment.
To Next Page
Loading...
Need help?
General
