iii
2007 − 2015 Reliable Controls
®
Corporation. All rights reserved.
The following symbols are used to draw your attention to important information.
Firmware versions starting with 8 require a configuration setting to allow the controller to
support legacy Reliable Controls Protocol (RCP). This document describes product oper-
ation with firmware version 8 running without RCP support. Refer to the legacy version of
this document for a description of product operation with RCP support enabled.
2015 Reliable Controls
®
Corporation
All rights reserved
Printed in Canada
This manual is for information purposes only. The contents and products described are
subject to change without notice. Reliable Controls
®
Corporation makes no representation
with respect to this manual. In no event shall Reliable Controls
®
Corporation be liable for
damages, direct or incidental, arising out of or related to the use of this manual. No part of
this document may be reproduced or transmitted in any form or by any means, without the
express written permission of Reliable Controls
®
Corporation.
www.reliablecontrols.com
Reliable Controls, RC-Studio, RC-Toolkit and the Reliable Controls logo are registered trademarks of Reliable Controls
Corporation.
BACnet
®
is a registered trademark of ASHRAE.
MACH-ProCom, MACH-ProSys, MACH-System, MACH-Global, MACH1, MACH2, MACH-Air, MACH-Zone,
MACH-Stat, SMART-Sensor, SMART-Space, MODBUS-Link, RC-RemoteAccess, MACH-ProWebCom, MACH-
ProWebSys, MACH-ProZone, MACH-ProAir, MACH-ProPoint, MACH-Pro1, MACH-Pro2, and MACH-ProWeb are
trademarks of Reliable Controls.
10/9/15 JW
The exclamation symbol is used to highlight material that requires caution or thought
before implementation.
The light bulb symbol is used to highlight helpful information and practices.
Reliable Controls Corporation Tel: 250-475-2036
120 Hallowell Road Fax: 250-475-2096
Victoria, BC, Canada, V9A 7K2 Toll Free: 1-877-475-9301
To Next Page
Loading...
Need help?
General
